G
There are two ways to
program
the remote control
;
Automatic Code Search or Direct Entrv.
1
|
Turn on the component
you
want to controt
[TV,
VCR
or DVDI.
2l Press and hotd the component
key
you
want to
program.
Hotding the component key untit the LED
on the remote control turns on, then release the
kev.-
O
3l Point the remote at the component,
press
and
retease the
OUP
I
a
I
button, then wait three
seconds or
untiI the LED stops ftashing.
At this
point
the remote
control is searching for the
correct code
to
program.
lf, after three seconds, the
component
you
want
to
control
does not turn off,
press
and retease
€)UP
I
I
button
again to te[[ the
remote to search the next set of codes.
4l lf the component
you
want to control does turn off;
Press and retease
OOK
button
,
then the LED btinks
three times.
GENERAL INFORMATION
lV. Proqraminq the
Remote Control
Locking the votume controls to a sing[e device makes it easier to control
volume, without having
to
guess
whether the volume wi[[ change. lf
you
lock the remote's
volume controls to the TV,
you
witt atways be able to
change
the volume
to the tevet
you
want, without having to adjust it on
multipte devices.
It
you
want to lock the
volume
for the
5TB component
;
1
|
Press and hold
the 5TB component key until the LED on the remote control turns on.
2l Enter 3-digit code, 9 9 9 .
3l Press
and
release
the STB component key, then the LED btinks three times.
Untocking volume contro[
;
lf
you
want to
unlock the
volume
for the 5TB component
;
1
I
Press and hotd the 5TB component key untiI
the LED on the remote controt turns on.
2l
Enter 3-digit code, 9 9 9 .
3l Press and retease the STB
component key, then the LED btinks three times.
tv. minq the Remote Control
-,11.,u,s,!19,Dlgqt
E!t.':y]!lS,U9{___ __
1
|
Turn on the component
you
want to control
[TV,
VCR or DVD].
2l Locate the enclosed Code List. Find
your
brand of the component
you
want to controt,
3l Press and hold the component key
you
want to
program.
Hotding the component key untiI the
LED on the remote control turns on, then release the key.
4l Enter 3-digit code from the code tist, then the LED btinks three times.
5l lf
you get
no response, repeat these steps using the. next code listed for
your
brand untiI the
component responds to the remote controI command.
To Next Page
Loading...