9
2.6 LCD display
After initially applying power to the product, it will automatically enter run mode. The current
conductivity or TDS will then be displayed or 000 if a purge time has been set or the product
has not been calibrated.
In normal operation (run mode) the display shows the actual Total Dissolved Solids (TDS)
value in µS/cm or ppm, depending on the option chosen.
All ranges and operating parameters are selected using the software menu.
Once fully commissioned, the TDS value will alternate with information about alarms and the
valve status.
Example of alarm status:
If a blowdown occurs, 'bLd' will be displayed, followed by the type of blowdown.
Example of valve status:
Actual TDS value
To Next Page
Loading...