Spirent TestCenter - Getting Started Procedures

Getting Started with Spirent TestCenter | 11
Getting Started
In this chapter. . .
• About Chassis Controllers . . . . 12
• About the Virtual Spirent LabServer . . . . 13
• Summary of Installation Procedures . . . . 13
• Procedure 1: Check System Requirements . . . . 15
• Procedure 2: Verify Contents of Shipment . . . . 16
• Procedure 3: Install Spirent TestCenter Software . . . . 17
• Procedure 4: Chassis and Appliance Firmware Support . . . . 24
• Procedure 5: Perform Cable Connections . . . . 26
• Procedure 6: Install the Ferrite Block . . . . 32
• Procedure 7: Connect Power . . . . 34
• Procedure 8: Set the Chassis IP Address . . . . 40
• Procedure 9: Confirm the Ethernet Link . . . . 47
• Procedure 10: Using the Authenticate Mode (optional) . . . . 48
• Procedure 11: Obtain Your License Key . . . . 50
• Procedure 12: Connect to a DUT/SUT . . . . 54
• Procedure 13: Configure and Run Tests . . . . 56