Getting Started
Summary of Installation Procedures
14 | Getting Started with Spirent TestCenter
8 Set up the chassis IP address, netmask, and gateway (page 40).
9 Confirm the Ethernet link: Ping the Ethernet link between the PC and the Spirent
chassis. If this is unsuccessful, check the TCP/IP stack on the PC and add the
appropriate IP address (page 47).
Using the Authenticate Mode (optional)
10 Authenticate mode allows the user to set a password on the chassis or appliance, so
only authorized users can access the equipment (page 48).
Obtain and Install Your License Key
11 Obtain the license key for your Spirent chassis and copy it to your chassis (page 50).
Connect the Chassis to the DUT/SUT
12 Connect Spirent hardware to the device(s) under test, check cabling, and ensure that
EMI guidelines are met (page 54).
Install and Configure the Spirent Virtual LabServer
Virtual LabServer customers, follow the installation and configuration instructions in
Appendix A (page 57) to complete your Spirent system installation.
Configure and Run Tests
13 Open a Spirent TestCenter application and set up a test (page 56), or initialize an
automation API and set up a test.
Note: Your Spirent chassis, modules, and appliances are shipped with current operating
system firmware. All modules are installed in your chassis.
To Next Page
Loading...
