SPL Phonitor xe - Standard Headphone Output

30
Specications
Standard headphone output
Warning: Never connect a mono jack cable to the standard headphone output (front panel stereo jack).
Make sure that the stereo jack is fully inserted, otherwise a short circuit might damage the headphone
amplifier!
• . mm TRS connector (front and rear side)
• Pin wiring: Tip = Left, ring = right, sleeve = GND
• Impedance: . ohm
• Attenuation factor:  @  ohms
• Frequency range:  Hz to  kHz ( - dB)
• Crosstalk at  kHz: - dB
• THD & N: .% (at  dBu,  kHz,  kohms load)
• Noise (A-weighted): - dB
• Dynamic range: . dB
Max. Output power (at +30 dBu @ 1 kHz)
•  x  W at  Ohm impedance
•  x  W at  Ohm impedance
• x . W at  Ohm impedance
• x . W at  Ohm impedance
• x . W at  Ohm impedance