Why is my SPM U-go Ice Cream Maker leaking from the front outlet pipe?
If your SPM Ice Cream Maker is leaking from the front outlet pipe, it may be because the contact between the beater shaft and the bushing of the rear seal has not been lubricated. Remove the beater and lubricate the shaft and bushing.
General| Brand | SPM |
|---|---|
| Model | U-go |
| Category | Ice Cream Maker |
| Language | English |
Details the physical size and weight of the U-go appliance.
Specifies the maximum sound pressure level of the appliance.
Specifies required clearances for ventilation and suitable environmental conditions for installation.
Instructions for cleaning the condenser to ensure optimal cooling system performance.
Guidance on when and how to replace various seals: beater, tap, and shaft seals.
Steps for properly storing the appliance during inactive periods like winter.
Information on storing product, emphasizing manufacturer instructions.
Explains and calculates the volume increase of mix during processing.
Addresses issues with insufficient cooling when the compressor is active.
Addresses issues with insufficient cooling when the compressor is inactive.
Explains potential causes and solutions for excessive noise from the appliance.
Troubleshoots scenarios where the appliance fails to start despite the main switch being on.
Identifies causes and solutions for leaks originating from the front outlet pipe.
Diagnoses why no product dispenses despite the appliance running and tank filled.
Addresses issues related to the dispensing tap leaking.
Troubleshoots why the beater mechanism fails to rotate.
Explains causes for unusual noise during the beater's operation.
Solves problems where control panel buttons are unresponsive.
Interprets flashing LEDs on the ON button and level 3 consistency.
Explains the meaning of a flashing LED for consistency level 1.
Addresses the scenario where ON and WASH button LEDs flash simultaneously.
Explains the cause of the product level LED flashing.
Troubleshoots the blinking indicator for consistency level 3.
To Next Page
