50
1.
1.
Connect all wires very carefully, and make sure that all wires are correctly connected.
Remove the screw in the base frame first.
Step 3: Install the meter
Step 4: Remove the screw in base frame
2.
2.
Use 4 Screw M4*15 to fasten the meter to the steel board (Tighten these 4 screws)
Turn power on and start the machine. If all functions work well, tighten all screws
1. Use 4 Screw M4.2*15 to fasten left and right decorative covers.
Step 5: Install decorative covers
Screw M4.2*15
To Next Page
Loading...
