SPRIANO® TECHNOLOGIES - www.spriano.it – spriano@terranova-instruments.com
a TERRANOVA® Srl brand - www.terranova-instruments.com - VAT IT07848810151
Factory & Sales: Via Gramsci 1 – 26827 Terranova dei Passerini (LO) – Italy
Head Office: Via Rosso Medardo 16 – 20159 Milano – Italy Ph: +39 0377 919119 – Fax: +39 0377 855720
3 INSTALLATION
3.1 TRANSMITTER IDENTIFICATION
Transmitter data can be found on the nameplate fixed on the top of transmitter enclosure (see
MARKING). The Serial Number must be quoted at the occurrence of a specific request to the
manufacturer.
3.2 GENERAL MOUNTING REQUIREMENTS
Prior installation shall be observed following considerations:
- Check whether Transmitter’s operating conditions are within the limits as reported in the
nameplate, technical specifications sheets and/or label.
- Make sure that the operating conditions are compatible with the specification given to the
manufacturer.
MANDATORY!
- For measurement in the presence of particularly hot liquids (e.g. steam) make
sure that the Transmitter is supplied with a suitable finned arm.
- For viscous liquids or those containing solid particles in suspension make sure
that the connection to the process is a suitable one in order to avoid clogs.
WARNING!
Direct sunlight may cause serious damages to the instrument.
Never install standard Transmitter under the sun or in any other location which
could cause direct overheating through radiation.
Figure 2: mounting requirements
To Next Page
Loading...
