7. Trouble of the light’s extinction in shaft.
The light in shaft automatically shut down when you switch to Inspection or Emergency Operation modes:
The shaft’s light wiring on CN7-I plug of the 220SP board is wrong. Check the diagram and fix the wiring
8. Brakes faults
If you consistently encounter the following faults « BRAKES UNRAISED » , « BRAKES UNRELEASED» or « BRAKE
FEEDBACK », the brake control contacts are not of the right type
(CFR1 & CFR2 LEDS on plug CN13-I of 220SP board).
Check the contact type configured (NC or NO) for these inputs in the following menu:
+ …
+ …
+ …
Set the kind of your brake contacts (N.O or N.C.)
+ …
+ …
If you do not have brake control contacts, then simply disable the brake control function in this menu :
+ …
Set to « OFF »
To Next Page
Loading...
