PCM
+
Operation Manual 11
Sending readings to a PDA or PC
When a reading is saved the data is automatically saved
within the locator. If the data is to be sent to a PDA or
PC the PDA or PC should have Radiodetection’s PCM
+
SurveyCERT
™
application installed and the PCM
+
must
be paired with either of the devices that is being used.
For details of using Radiodetection’s PCM
+
SurveyCERT
™
application go to www.radiodetection.com/pcm+.
Uploading data
Note: To upload PCM
+
saved results, Radiodetection’s
PCM
+
SurveyCERT
™
application is required on the target
PC.or PDA. Please refer to Section 9 for further details.
PCM
+
SurveyCERT
™
is a free application available for
download at www.radiodetection.com/pcm+.
The PCM+ provides the user with the opportunity to send
data from the locator to a PDA or PC as the data is saved
or by uploading the entire log to a PDA or PC at a later
date.
Once the SurveyCERT
™
application has been loaded onto
the PDA or PC the PCM
+
must be paired with the PDA or
PC to transfer data from the PCM
+
.
For details of using Radiodetection’s PCM
+
SurveyCERT
™
application go to www.radiodetection.com/pcm+.
Erase All Stored Datalogs
The erase function can be used to completely erase all
stored logs within the PCM
+
. To erase all stored logs carry
out the following:
Momentarily press the On/Off key to enter the
PCM
+
menu.
Scroll through the menu options until DEL? is
displayed.
Momentarily press the On/Off key and you will
be given a choice, either NO or YES. To delete all
stored logs use the Up/Down key to select YES and
momentarily press the On/Off key.
•
•
•
Review Mode
Saved data within the PCM
+
can be reviewed.
To review stored logs carry out the following:
Momentarily press the On/Off key to enter the
menu and scroll through the menu options using
the Up/Down keys until VIEW is displayed.
Momentarily press the On/Off key and the last
stored log will be displayed.
To scroll through the stored logs press the
Up/Down key.
To exit review mode press the On/Off key once.
Overwriting saved logs
Previously saved logs can be overwritten. To overwrite
saved logs carry out the following:
Momentarily press the On/Off key to enter the menu.
Scroll through the menu using the Up/Down keys
until View is displayed.
Momentarily press the On/Off key and the last saved
log will be displayed.
Scroll through the saved logs using the Up/Down
key. Once a particular log has been selected press
the Antenna key and the locator will revert to the
main screen. When a measurement is taken, the log
number selected to be overwritten will be displayed
on the screen. Accepting the measurement will
overwrite the selected log. If the measurement is
rejected the next measurement taken will be stored
at the end of the log le and not the log that was
viewed before. Each time a log is required to be
overwritten the log must be selected using the
procedure above.
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
