the status of its main elements, including cellular signal strength, battery power level, and space used on the SD
card.
Your new settings will be applied the next time your CELL-LINK communicates with the SPYPOINT app or website.
NOTE
Before starting the CELL-LINK, make sure you have successfully configured your trail camera according to your
preferences and that you have done this by following your camera’s User Manual.
CONFIGURATION: MAIN SETTINGS
Here are the recommended camera settings to ensure the optimal performance of your CELL-LINK:
A low-resolution photo format.
Precisely adjust the date and time.
A delay no shorter than 1 minute between each detection.
In Time-lapse mode, a delay no shorter than 1 minute.
NOTE
The CELL-LINK doesn’t support video transfers. However, if you configure your camera to take a picture before each
of your videos, that picture will be sent to you via the CELL-LINK.
STARTING YOUR CELL-LINK
BEFORE TURNING YOUR CAMERA ON
Refer to the image below to familiarize yourself with the meaning of the STATUS and SIGNAL LEDS. These light
indicators will guide you along the startup process.
STARTING YOUR CELL-LINK
To Next Page
Loading...
