We recommend that you watch our video which will guide you through the different installation steps. Go to
www.spypoint.com/en/support.
1. Open your camera door.
2. Take the cable with SD adapter and insert the SD card extemity (#CL-CBL) in the corresponding slot.
3. Pull the cable with SD adapter down and hold it against the camera. We suggest that you make at least one loop
with the cable and place it inside the camera housing. This way, the SD card will not be disconnected if the cable is
pulled (when you close the camera door, for example). The cable should therefore hang freely on the outside of the
camera. Important: Avoid running the cable in front of the lenses or other essential components.
4. Shut the camera door and lock the latch.
5. Run the cable behind the camera and upwards so that the end of the cable sticks out of the top of the camera, so
that you can connect it to the CELL-LINK.
To Next Page
Loading...
