34
Lever Brake Hose Installation
Use a flare nut crowfoot with a torque wrench to tighten the Use a flare nut crowfoot with a torque wrench to tighten the
compression nut to 8 N·m (71 in-lb). compression nut to 8 N·m (71 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a shop Spray isopropyl alcohol on the lever body and clean it with a shop
towel.towel.
Slide the hose boot onto the lever.Slide the hose boot onto the lever.
⚠ CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
7
8 mm flare nut wrench 8 N·m (71 in-lb)
To Next Page
Loading...
Need help?
General
