SRAM G2 RS User Manual

33
Lever Brake Hose Installation
Lever Brake Hose Installation
Slide the lever hose boot and compression nut away from the Slide the lever hose boot and compression nut away from the
compression fitting.compression fitting.
Cut the hose to install a new barb and compression fitting.Cut the hose to install a new barb and compression fitting.
NOTICE
You must install a new hose barb and compression fitting before
connecting the hose to the brake lever.
Apply DOT grease to the hose barb threads. Thread the hose barb into Apply DOT grease to the hose barb threads. Thread the hose barb into
the hose until it is flush with the end of the hose.the hose until it is flush with the end of the hose.
NOTICE
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
Thread the compression fitting over the hose barb, counter-clockwise, Thread the compression fitting over the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb.until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.The compression fitting is reverse threaded.
Apply DOT grease to the outside of the compression fitting and the Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.Install the compression fitting and nut threads of the compression nut.Install the compression fitting and nut
into the lever.into the lever.
1
2
SRAM Hydraulic Hose Cutter
3 4 5
T8 T8
6
DOT grease

SRAM G2 RS Specifications

General

Brake Type	Hydraulic Disc
Lever Material	Aluminum
Caliper Design	2-Piston
Brake Pad Type	Organic
Reach Adjust	Yes
Rotor Size Compatibility	140mm, 160mm, 180mm, 200mm