Name: SRAM G2 RS
Brand: SRAM
Rating: 4 (1 reviews)

To Next Page

To Previous Page

RS Lever Blade Installation

Use needle nose pliers to install the SwingLink bushings.Use needle nose pliers to install the SwingLink bushings.

If the SwingLink bushings fall out easily, apply a small amount of DOT If the SwingLink bushings fall out easily, apply a small amount of DOT

grease to the bushings to help hold them in place.grease to the bushings to help hold them in place.

Place the SwingLink pushrod into the piston.Place the SwingLink pushrod into the piston.

Line up the hole in the SwingLink with the hole in the bushings, then Line up the hole in the SwingLink with the hole in the bushings, then

push the pivot pin into the hole until it stops.push the pivot pin into the hole until it stops.

Needle nose pliers

Questions and Answers:

Need help?

Do you have a question about the SRAM G2 RS and is the answer not in the manual?

SRAM G2 RS Specifications

General