21Lever Blade Installation
Apply SRAM® DOT grease onto the compression nut and install the
compression fitting and nut into the lever.
Use a flare nut crowfoot with a torque wrench to tighten the
compression nut to 8 N·m (71 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a rag.
⚠ CAUTION
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions, visit www.sram.com/service.
18 14
15
8 mm flare nut crowfoot 8 N·m (71 in-lb) 22 mm
To Next Page
Loading...
