SRAM level ultimate - Page 34

34Lever Blade Installation
Press the bladder into the reservoir cap. The bladder must be flush with
the edge of the cap to be properly installed.
Place the reservoir cap/bladder assembly onto the lever body.
Use a torque wrench and a T10 TORX
®
bit socket to tighten each
reservoir cap bolt to 1.1-1.3 N·m (10-12 in-lb).
Spray isopropyl alcohol on the lever body and clean it with a
shop towel.
6 6
7
8
T10 TORX bit 1.1-1.3 N•m (10-12 in-lb) 22 mm
9