35Lever Blade Installation
Cut the hose to install a new barb and compression fitting.
NOTICE
You must install a new hose barb and compression fitting before recon-
necting the brake lever to the hose.
Apply DOT grease to the hose barb threads. Thread the hose barb into
the hose until it is flush with the end of the hose.
NOTICE
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
Install the compression nut onto the hose.
Thread the compression fitting over the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.
Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.
To Next Page
Loading...
