16
Lower Leg Removal
Ultimate:Ultimate: Loosen the Loosen the spring sidespring side bottom bolt 3 to 4 turns. bottom bolt 3 to 4 turns.
Select/Select+Select/Select+: Loosen both bottom bolts 3 to 4 turns.: Loosen both bottom bolts 3 to 4 turns.
Insert a 5 mm extension or hex wrench into the bolt head of the Insert a 5 mm extension or hex wrench into the bolt head of the spring spring
sideside lower leg. Strike the wrench to dislodge the shaft from the lower lower leg. Strike the wrench to dislodge the shaft from the lower
leg. The bolt head should contact the bottom of the lower leg.leg. The bolt head should contact the bottom of the lower leg.
Remove the Remove the spring side spring side bottom bolt. Clean the bolt and set it aside. bottom bolt. Clean the bolt and set it aside.
Ultimate:Ultimate: Use a 10 mm socket and extension to remove the rebound Use a 10 mm socket and extension to remove the rebound
nut on the nut on the damper sidedamper side lower leg. lower leg.
Insert a 5 mm hex wrench into the rebound damper shaft. Strike the Insert a 5 mm hex wrench into the rebound damper shaft. Strike the
wrench to dislodge the shaft from the lower leg. wrench to dislodge the shaft from the lower leg.
Push the shaft into the lower leg. Push the shaft into the lower leg.
Discard the crush washer and rebound nut. Discard the crush washer and rebound nut.
5
Ultimate: 5 mm Spring Side Only Select / Select +: 5 mm Both Sides
6
Spring Side: 5 mm & Mallet Spring Side
7
Ultimate: 10 mm Damper Side Ultimate: 5 mm Damper Side
Ultimate: 5 mm Damper Side
To Next Page
Loading...
