SRAM Rockshox SID SL - Air Spring Service; Travel Change Adjustment - Optional; Bottomless Token - Optional Installation

23
Air Spring Service
Air Spring Service
⚠ WARNING- EYE HAZARD
Verify all pressure is removed from the fork before proceeding. Depress the schrader valve again to remove any remaining air pressure. Failure to
do so can result in injury and/or damage to the fork.
Travel Change Adjustment - Optional
To increase or decrease the travel in your SID fork, the air spring must be replaced with the correct length air spring shaft assembly. Refer to the
RockShox Spare Parts Catalog available on our website at www.sram.com/service for spare part kit details.
Bottomless Token - Optional Installation
Bottomless Tokens can be added to, or removed from, the air top cap to fine-tune the bottom out feel and spring curve. Bottomless Tokens reduce
the air volume in your fork to create greater ramp at the end of the fork travel. Add tokens to maintain your fork's bottomless feel.
Remove the top cap.Remove the top cap.
Thread a Bottomless Token into another token or into the bottom of Thread a Bottomless Token into another token or into the bottom of
the top cap. the top cap.
NOTICE
The maximum amount of Bottomless Tokens for all SID forks is
3 tokens. Do not exceed.
Tighten the token(s). Tighten the token(s).
200 Hour Service Continue the 200 Hour Service for a Continue the 200 Hour Service for a DebonAir SpringDebonAir Spring. .
Top Cap/Cassette Tool
1
2
3
8 mm 4 N·m (35 in-lb) Top Cap/Cassette Tool