SRAM Rockshox SID SL - 200 Hour Service: Charger Damper RL Assembly; Damper Assembly and Travel Measurement

55
Damper Assembly
200 Hour Service Damper Assembly
Apply grease to the rebound damper shaft. Insert the rebound damper Apply grease to the rebound damper shaft. Insert the rebound damper
shaft into the recessed end of the seal head.shaft into the recessed end of the seal head.
Slide the seal head toward the piston.Slide the seal head toward the piston.
Insert the rebound adjuster knob into the rebound damper and rotate Insert the rebound adjuster knob into the rebound damper and rotate
it counter-clockwise until it stops. This is the full open position.it counter-clockwise until it stops. This is the full open position.
1
2.5 mm hex or Rebound Adjuster Knob
2