SRAM Rockshox SID SL - DebonAir Spring Assembly Process; Greasing and Installing Spring Components

27
DebonAir Spring Service
Remove the air piston outer o-ring.Remove the air piston outer o-ring.
Clean the air piston. Clean the air piston.
Apply grease and install a new o-ring. Apply grease and install a new o-ring.
Apply a liberal amount of grease evenly around the end of a clean Apply a liberal amount of grease evenly around the end of a clean
plastic dowel, approximately 60 mm from one end. Use the dowel to plastic dowel, approximately 60 mm from one end. Use the dowel to
apply the grease to the inside surface of the upper tube, approximately apply the grease to the inside surface of the upper tube, approximately
60 mm into the tube. 60 mm into the tube.
Apply a liberal amount of grease around the air shaft. Apply a liberal amount of grease around the air shaft.
SID SL: Install the seal head assembly onto the air shaft.SID SL: Install the seal head assembly onto the air shaft.
SID: Install the top out bumper cup and bumper cone.SID: Install the top out bumper cup and bumper cone.
SID SL SID
9
10
11
SID SID
SID SL