34
Bleed Procedure
Inject the oil into the damper assembly. Inject the oil into the damper assembly.
Push the assembly down to compress the rebound shaft. The syringe Push the assembly down to compress the rebound shaft. The syringe
will fill up. will fill up.
Depress the syringe to inject oil into the damper assembly and allow Depress the syringe to inject oil into the damper assembly and allow
the rebound shaft to fully extend. the rebound shaft to fully extend.
Repeat cycling the fluid 3-4 times. Repeat cycling the fluid 3-4 times.
Push the syringe handle down, then release the plunger. Allow Push the syringe handle down, then release the plunger. Allow
the bladder to come to a natural resting position by waiting a few the bladder to come to a natural resting position by waiting a few
moments until the syringe stops filling. moments until the syringe stops filling.
Use a shop towel to cover the bleed tip and bleed port, then unthread Use a shop towel to cover the bleed tip and bleed port, then unthread
and remove the syringe.and remove the syringe.
Make sure the damper is fully extended and there is a small amount Make sure the damper is fully extended and there is a small amount
of positive pressure in the system before the syringe is removed. This of positive pressure in the system before the syringe is removed. This
prevents air getting back into the damper.prevents air getting back into the damper.
⚠ CAUTION - EYE HAZARD
Oil will eject from the bladder assembly if the bladder is not in its
resting position. Wear safety glasses.
Install the bleed screw. Install the bleed screw.
8
9
T10
10
To Next Page
Loading...
