49
Charger 2 Damper Installation - Remote
Top Cap and Spool with Groove: Top Cap and Spool with Groove: Remove and discard the glide ring in Remove and discard the glide ring in
the bottom of the spool. Clean the spool. the bottom of the spool. Clean the spool.
Apply grease to the spool groove. Install the new glide ring. Apply Apply grease to the spool groove. Install the new glide ring. Apply
grease on the glide ring. grease on the glide ring.
RL R:RL R: Install the spool. Install and tighten the spool retention screw. Install the spool. Install and tighten the spool retention screw.
Install the spool with the cable set screw oriented within the Install the spool with the cable set screw oriented within the
87 degree range in the diagram. 87 degree range in the diagram.
Hand tighten the cable stop collar bolt, and then tighten. Consult the Hand tighten the cable stop collar bolt, and then tighten. Consult the
remote user manual for cable installation instructions.remote user manual for cable installation instructions.
NOTICE
Do not overtighten the cable stop collar bolt. Overtightening the bolt
may result in damage to the remote top cap and cause the cable
to rub.
200 Hour Service Continue the 200 Hour Service with Lower Leg Installation.
3
Grease Grease
2 mm 1 Nm (9 in-lb)
4
RL R RL R
87°
2 mm 0.4 N·m (4 in-lb)
To Next Page
Loading...
