SRAM Rockshox SID SL - Page 58

58
Damper Assembly
Tighten the top cap. Tighten the top cap.
Tighten the rebound damper seal head. Tighten the rebound damper seal head.
Pull the rebound damper to full extension. Pull the rebound damper to full extension.
Use the table to find the B measurement for your fork's travel. Secure Use the table to find the B measurement for your fork's travel. Secure
a plastic cable tie around the shaft at the B dimension for your fork's a plastic cable tie around the shaft at the B dimension for your fork's
travel.travel.
Do not push the damper into the tube any further.Do not push the damper into the tube any further.
Fork travel (mm) B (mm)
100 55
120 34
Remove the damper from the vise. Loosely wrap a shop towel over the Remove the damper from the vise. Loosely wrap a shop towel over the
damper cartridge purge holes. Hold the damper vertical and slowly damper cartridge purge holes. Hold the damper vertical and slowly
pull the shaft out to full extension. Slowly push the rebound damper pull the shaft out to full extension. Slowly push the rebound damper
shaft into the tube until the cable tie contacts the seal head, then stop. shaft into the tube until the cable tie contacts the seal head, then stop.
Do not push the damper in any further. Do not push the damper in any further.
Repeat 3-5 more times. This will allow any excess oil and air to escape Repeat 3-5 more times. This will allow any excess oil and air to escape
from the system. from the system.
Remove the bottom bolt. Clean the damper. Do not remove the cable Remove the bottom bolt. Clean the damper. Do not remove the cable
tie.tie.
⚠ CAUTION
Oil may exit the cartridge tube purge holes. Wear safety glasses
and keep your eyes and face away from the purge holes when
compressing the rebound damper.
Top Cap/Cassette Tool 9 Nm (80 in-lb) 24 mm 9 Nm (80 in-lb)
9
19 mm 9 Nm (80 in-lb)
See Table for Value
B
10
11