VENTILATION, HEATING, AIR CONDITIONING AND AIR PURIFICATION SYSTEM
9-15
DEFOGGING AND DEFROSTING
Inside
1. Press the defroster switch.
2. Adjust the fan speed with the fan speed control speed.
3. To quickly remove the fog on the glass, set the switch at
high speed position.
4. To prevent the fog generating on the glass, setting the air
source selection switch to the fresh air intake mode is
recommended.
Defroster switch
Automatic air conditioner
Manual air conditioner
Outside
1. Press the defroster switch.
2. Adjust the fan speed with the fan speed control speed.
3. To quickly remove the fog on the glass, set the switch to
high speed position.
4. Set the temperature control switch to hot position.
When you press this switch, the air conditioner turns on automati-
cally and the system selects the fresh air intake mode.
NOTE
• To prevent the fog generating on the glass, setting the air source
selection switch to the fresh air intake mode is recommended.
• An extended air conditioner operation in bi-level mode or defrost
mode may cause the fogged outside glass due to high tempera-
ture difference between inside and outside of the vehicle. In this
case, change the air flow to vent mode and use the low fan speed.
• Especially in winter and summer, to avoid glass fogging, remove
any obstacles such as snow or leaves on the air inlets.
CAUTION
A120_RHD_09_Air Conditioning System.p65 2006-10-02, ¿ÀÀü 11:06Page 15 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
