9. Federal Communications Commission (FCC) and ISED Canada
9.1 FCC Compliance Statement
Changes or modifications not expressly approved by STMicroelectronics could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC ID: YCP-MB180300
Model mane: MB1803B-01
Applicable FCC rules: This module has been approved under FCC part 15C 15.247 in the frequency
range 2400-2483.5MHz. This modular transmitter is only FCC authorized for this specific rule part.
Specific operational use conditions :
- The module is limited to OEM installation ONLY.
Limited module procedures are not applicable to this application.
Trace antenna design is not applicable to this application.
Radio Frequency (RF) Exposure Compliance of Radio communication: To satisfy FCC RF Exposure
requirements, a separation distance of 20cm or more should be maintained between the antenna of this device
and persons during operation. To ensure compliance, operation at a closer distance than this is not
recommended. This transmitter must not be co- located or operating in conjunction with any other antenna or
transmitter.
List of antenna type approved: Not applicable (Antenna is printed on the PCB module)
End Product Labeling: if the host is marketed so that end users do not have straight forward commonly
used methods for access to remove the module so that the FCC ID of the module is visible; then an
additional permanent label referring to the enclosed module shall be added:
“Contains Transmitter Module FCC ID: YCP-MB180300” or “Contains FCC ID: YCP-MB180300” must
be used.
Additional testing requirements:
- If testing of the host product with this transmitter installed and operating is necessary (to verify that the
host product meets all the applicable FCC rules), a test mode for this specific module is available upon
request to STMicroelectronics.
-The host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification. (For example, Part 15 Subpart B)
To Next Page
Loading...
