9.2 ISED Compliance Statement
IC: 8976A- MB180300
Product Marketing Name: MB1803B
HVIN: MB1803B-01
This device contains licence-exempt transmitter(s)/receivers(s) that comply with Innovation, Science and
Economic Development Canda’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
Applicable ISED-CANADA rules: This module has been approved under RSS-247 in the frequency range
2400-2483.5MHz. This modular transmitter is only ISED authorized for this specific rule part.
Specific operational use conditions:
- The module is limited to OEM installation ONLY.
- If other parameters (power setting) other than the type documented in the filing, a class 2
permissive change must be filed with ISED-CANADA.
Limited module procedures are not applicable to this application.
Trace antenna design is not applicable to this application.
Radio Frequency (RF) Exposure Compliance of Radio communication: To satisfy ISED-Canada RF Exposure
requirements, a separation distance of 20cm or more should be maintained between the antenna of this device and
persons during operation. To ensure compliance, operation at a closer distance than this is not recommended. This
transmitter must not be co- located or operating in conjunction with any other antenna or transmitter.
This radio transmitter IC: 8976A-MB180300 has been approved by Innovation, Science and Economic Development
Canada to operate with the PCB antenna printed on the module.
List of antenna type approved: Not applicable
End Product Labeling: If the IC number is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following: “Contains IC: 8976A-MB180300”
Additional testing requirements:
- If testing of the host product with this transmitter installed and operating is necessary (to verify that the
host product meets all the applicable ISED-Canada rules), a test mode for this specific module is
available upon request to STMicroelectronics.
- The host product manufacturer is responsible for compliance to any other ISED rules that apply to the
host not covered by the modular transmitter grant of certification. (For example, ICES-003)
To Next Page
Loading...
