5V_UCPD
5V_UCPD is the DC power supply connected to the USB Type-C
®
user connector (CN2) when it is used as a sink
port. In this case, the JP3 jumper must be set on [7-8] to select the UCPD power source. The green LED (LD5) is
turned ON.
5V_UCPD configuration: The JP3 jumper must be set on [7-8] as shown in Figure 10:
Figure 10. JP3 [7-8]: 5V_UCPD power source
DT59258V1
Green LED
(LD5)
JP3 [7-8]
User USB Type-C
®
connector (CN2)
UM3276
Hardware layout and configuration
UM3276 - Rev 1
page 18/40
To Next Page
Loading...
