UM2448 Rev 6 47/49
UM2448 Federal Communications Commission (FCC)
48
Appendix A Federal Communications Commission (FCC)
15.3 FCC Compliance Statement
15.3.1 Part 15.19
Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Part 15.21
Any changes or modifications to this equipment not expressly approved by
STMicroelectronics may cause harmful interference and void the user's authority to operate
this equipment.
Part 15.105
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception which can be determined by turning the equipment off and on, the user
is encouraged to try to correct interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Use a USB cable with a length lower than 0.5 m and added ferrite on the PC's side.
Other certifications
• EN 55032 (2012) / EN 55024 (2010)
• CFR 47, FCC Part 15, Subpart B (Class B Digital Device) and Industry Canada ICES-
003 (Issue 6/2016)
• Electrical Safety qualification for CE marking: EN 60950-1
(2006+A11/2009+A1/2010+A12/2011+A2/2013)
• IEC 60650-1 (2005+A1/2009+A2/2013)
Note: The sample examined must be powered by a power supply unit or auxiliary equipment
complying with standard EN 60950-1: 2006+A11/2009+A1/2010+A12/2011+A2/2013, and
must be Safety Extra Low Voltage (SELV) with limited power capability.
To Next Page
Loading...
