ST STLINK-V3SET - Features

Features UM2448
8/49 UM2448 Rev 6
1 Features
• Stand-alone probe with modular extensions
• Self-powered through a USB connector (Micro-B)
• USB 2.0 high-speed compatible interface
• Direct firmware update support (DFU)
• JTAG / serial wire debugging (SWD) specific features:
– 3 V to 3.6 V application voltage support and 5 V tolerant inputs (extended down to
1.65 V with the B-STLINK-VOLT or B-STLINK-ISOL board)
– Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm
pitch)
– JTAG communication support
– SWD and serial wire viewer (SWV) communication support
• SWIM specific features (only available with adapter board MB1440):
– 1.65 V to 5.5 V application voltage support
– SWIM header (2.54 mm pitch)
– SWIM low-speed and high-speed modes support
• Virtual COM port (VCP) specific features:
– 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant
inputs (extended down to 1.65 V with the B-STLINK-VOLT or B-STLINK-ISOL
board)
– VCP frequency up to 16 MHz
– Available on STDC14 debug connector (not available on MIPI10)
• Multi-path bridge USB to SPI/UART/I
2
C/CAN/GPIOs specific features:
– 3 V to 3.6 V application voltage support and 5 V tolerant inputs (extended down to
1.65 V with the B-STLINK-VOLT or B-STLINK-ISOL board)
– Signals available on adapter board only (MB1440)
• Drag-and-drop Flash programming of binary files
• Two-color LEDs: communication, power
Note: The STLINK-V3SET product does not provide the power supply to the target application.
B-STLINK-VOLT is not required for STM8 targets, for which voltage adaptation is performed
on the baseline adapter board (MB1440) provided with the STLINK-V3SET.