ST STM32F105 series

CAN bootloader AN2662
66/83 Doc ID 14156 Rev 1
Figure 51. Readout Unprotect command via CAN: device side
1. RDU_PRM = Readout Unprotect.
The STM32F105xx and STM32F107xx sends the messages as follows:
ACK message: Std ID = 0x92, DLC = 1, data[0] = ACK if the content of the command is
correct and ROP is not active else data[0] = NACK.

.O
AI
3TART2$5?02-

2ECEIVED
3END!#+MESSAGE
3END.!#+MESSAGE
%NDOF2$5?02-

9E S
3END!#+MESSAGE
$ISABLE2/0
'ENERATESYSTEMRESET
MESSAGEWITH
)$X