ST STM32H743I-EVAL - Table 3. Power Related Jumpers

DocID030511 Rev 1 15/69
UM2198 Hardware layout and configuration
68
Table 3. Power related jumpers
Jumper Description
JP9
JP9 is used to measure STM32 current consumption manually by a multimeter.
Default setting: Fitted
JP10
JP10 is used to select one of the six possible power supply resources.
To supply the STM32H743I-EVAL board through the USB connector of the ST-
LINK/V2-1 (CN23) set JP10 as shown to the right: (default setting)
To supply the STM32H743I-EVAL board through the jack (CN10), set JP10 as
shown to the right:
To supply the STM32H743I-EVAL board through the daughterboard connectors
(CN6 and CN7), set JP10 as shown to the right:
To supply the STM32H743I-EVAL board through the USB OTG2 FS (CN16), set
JP10 as shown to the right:
To supply the STM32H743I-EVAL board through the USB OTG1 FS (CN18), set
JP10 as shown to the right:

+6
)6
)6
'9
368
67ON
069

+6
)6
)6
'9
368
67ON
069

+6
)6
)6
'9
368
67ON
069

+6
)6
)6
'9
368
67ON
069

+6
)6
)6
'9
368
67ON
069
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.