Single speed pumps Installation and User’s Guide
English
4
IMPORTANT PUMP WARNING AND SAFETY INSTRUCTIONS
IMPORTANT NOTICE
Attention installer: This guide contains important
information about the installation, operation and safe use
of this product. This information should be given to the
owner and/or operator of this equipment after installation
or left on/near the pump.
Attention user: This manual contains important
information that will help you in operating and maintaining
this product. Please retain it for future reference.
Warnings and safety instructions for Pentair Aquatic
Systems pumps and other related products are available
at: www.pentairpooleurope.com
READ, FOLLOW AND SAVE THESE INSTRUCTIONS!
This is the safety alert symbol. When you see this symbol on your system or in this manual, look for
one of the following signal words and be alert to the potential for personal injury.
Warns about hazards that can
cause death, serious personal
injury or major property damage if
ignored.
Warns about hazards that may or
can cause minor personal injury or
property damage if ignored.
NOTE: Indicates special instructions not related to
hazards.
Carefully read and follow all safety instructions in this
manual and on equipment. Keep safety labels in good
condition; replace if missing or damaged.
When installing and using this electrical equipment, basic safety precautions should always be followed, include the
following:
Children should not be allowed to
play with the appliance.
RISK OF ELECTRICAL SHOCK
The pump must only be connected to sockets that have
been installed properly in accordance with the regulations
and are protected with a FI-safety switch (RCD,30mA).
CONNECT TO SUPPLY CIRCUIT
This unit must be connected only to a supply circuit that
is protected by a RCD. Such a RCD should be provided
by the installer and should be tested on a routine basis.
To test the RCD, push the test button. The RCD should
interrupt power. Push the reset button. Powers should be
restored. If the RCD fails to operate in this manner, the
RCD is defective. If the RCD interrupts power to the pump
without the test button being pushed, a ground current
is owing, indicating the possibility of an electric shock.
Do not use this pump! Disconnect the pump and have the
problem corrected by a qualied service representative
before using.
This pump is for use with permanent
swimming pools and may also be
used with hot tubs and spas if so marked. Do not use with
storable pools.
A permanently installed pool is constructed in/on the
ground or in a building such that it cannot be readily
disassembled for storage.
A storable pool is constructed so that it is capable of
being readily disassembled for storage and re-assembled
to its original integrity.
DANGER
To Next Page
Loading...
