Stack-On PC-1702-RFID - INITIAL CASE SETUP; Opening the Case with the Key; Installing and Managing Batteries

Tools Required:
Drill
Flat Head Screwdriver
10 mm Wrench
3/16” (5 mm) drill bit for drilling
into wood
GETTING STARTED
INSTALLING THE BATTERIES
When you first receive your case you will need
to open the cover with the key in order to install
the baeries. Baeries are included and are
located inside the case.
Pull the foam upward and away from the
baery compartment. Remove the baery
compartment by pushing the tab and pulling the
compartment out as shown. Install (4) AAA
alkaline baeries which are included. Reinstall
the compartment by hooking the back end in
place and snapping shut. CAUTION: Be careful
not to pinch any wires while reinstalling the
baery compartment.
Red light will flash and
beep once (if the sound
is turned on)
if baeries are installed correctly.
NOTE: If the baeries are low the lights will flash
red when the buons are pushed. Replace the
4 AAA baeries with new alkaline baeries as
described above.
NOTE: The key has also been provided if you lose
or forget your security code or the baeries run
low. If you lose your key, or any of your RFID
devices, you may purchase a replacement by
referencing the serial number located on the
back of the case. See secon regarding
replacement RFID device/keys for further
informaon.
To open the case, insert key into the lock and
turn clockwise unl the cover automacally
opens.
NOTE: You must turn the key back to the
locked posion before you are able to close
and lock the cover.
NOTE: Do not mix old and new baeries. Do
not mix alkaline, standard or rechargeable
baeries.
OPEN
OPEN
Baery Carriage
4 - AAA
baeries
REMOVE KEY
40720-1702
2
16
LOW BATTERY WARNING