EasyManua.ls Logo

Stack-On PC-1702-RFID - ELECTRONIC COMBINATION MANAGEMENT; Setting Up and Entering Your Combination; Combination Entry Lockout Details

Stack-On PC-1702-RFID
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• For security you must program your own
combinaon aer opening the case.
• Record your new combinaon on this form
or store your combinaon on our secure
website at stackon.com under Customer
Service.
If you write down your combinaon you must
keep this informaon in a secure place, away
from children, not inside the case.
USING THE
ELECTRONIC COMBINATION
Enter your combinaon using the buons.
The buons will light up green and there
will be one "beep"(if the sound is turned
on) for every entry. If you entered the
correct combinaon, the buons will flash
green twice, with two beeps and the door
will open. If the combinaon is incorrect
the case will beep 3 mes (if the sound is
turned on) and the red light will flash
3 mes.
NOTE: You will have 2 seconds between
individual entries before the case assumes
you have entered your complete
combinaon.
If an incorrect security code is entered 3
mes the case will beep 5 mes (if the
sound is turned on) and the red light will
flash 5 mes resulng in the case being
automacally locked out for 60 seconds
before you can try your code again. The
case will beep one me (if the sound is
turned on) and the green light will flash
once when the lockout period is over.
If the incorrect security code is entered 1
addional me the case will beep 5 mes
(if the sound is turned on) and the red light
will flash 5 mes resulng in the case being
automacally locked out for 5 minutes
before the code can be tried again. The
case will beep one me (if the sound is
turned on) and the green light will flash
once when the lockout period is over.
The case may sll be opened using the
supplied Key to override failed security code.
To close the case, push the lid closed unl
locked.
OPENING THE CASE USING
ELECTRONIC COMBINATION
1.
2.
3.
Example: (RIGHT) - (LEFT) -
(CENTER) - (LEFT) - (RIGHT)
Press the Reset Buon (3) located inside
the case. Two “beeps” will sound (if the
sound is turned on) and all 3 buons will
flash blue twice. You will have 5 seconds
to begin entering your combinaon or you
will have to start over.
Enter your own 3-8 buon combinaon by
pressing any combinaon of the 3 buons.
For Each combinaon entry a “beep” will
sound (if the sound is turned on) and all
the buons will light up green. If you
delay more than 5 seconds between
entries there will be 3 beeps (if the sound
is turned on) and 3 red flashes and you
will have to start over from step 1. Aer
you have finished entering your
combinaon, you will have 5 seconds to
press the Reset Buon to record your new
combinaon or you will have to start over
from step 1.
When you press the Reset Buon to record
your new combinaon, there will be two
“beeps” (if the sound is turned on) and all
3 buons flash blue twice, indicang your
new combinaon has been recorded.
If the combinaon you entered does not
acvate the locking mechanism, you will
need to go back to step 1 in this secon.
To confirm your combinaon was entered
correctly, turn the key to the locked
posion (the lid may remain open) and
follow the instrucons in the “OPENING
THE CASE USING YOUR COMBINATION”
secon.
4.
40720-1702
4
16

Related product manuals