Stack-On QAS-1512 - Installing the Batteries

40544-1507
2
18
INSTALLING THE BATTERIES
NOTE: Do not mix old and new baeries. Do not
mix alkaline, standard or rechargeable baeries.
If your safe includes a shelf, remove it for beer
access to the baery compartment. Push the baery
cover locking tab with a screwdriver to release the
cover. Install the (4) AA alkaline baeries as shown.
Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
NOTE: If the baeries are low the combination
buons will ash red when pushed. Replace with
4 new AA alkaline baeries as shown.
• For security you must program your own
combination aer opening the safe.
• Record your new combination on this form
or store your combination on our secure
website at www.stack-on.com under Service. If
you write down your combination you must
keep this information in a secure place, away
from children, not inside the safe.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
1.
2.
Press the Reset Buon (3) located inside the safe.
Two “beeps” will sound (if the sound is turned
on) and all 3 buons will ash blue twice. You
will have 5 seconds to begin entering your
combination or you will have to start over.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
For each combination entry a “beep” will sound
(if the sound is turned on) and all the buons
will light up green. If you delay more than 5
seconds between entries you will have to start
over from step 1. Aer you have nished
entering your combination, you will have 5
seconds to press the Reset Buon to record
your new combination or you will have to start
over from step 1.
Enter your own 3-8 buon combination by
pressing any combination of the 3 buons.
3.
When you press the Reset Buon to record
your new combination, there will be two
“beeps” (if the sound is turned on) and all 3
keys ash blue twice, indicating your new
combination has been recorded.
Reset Button