Stack-On TDS-42-SG-E-S - Battery Installation and Location; Battery Replacement and Indicators

BATTERY INSTALLATION
NOTE: When changing the baery, always hold
the baery connecng cap while disconnecng
or aaching the baery. Do not pull on the
wires. Doing this could cause the power supply
to become disconnected from the lock.
This safe uses one 9V alkaline baery. Under
normal use, baeries will last about 1 year.
When the baery is low and you press a buon
on the keypad, a red light will come on warning
you that the baery is low.
To test the baery, enter your security code.
If the baery is low the red light will come
on momentarily.
To replace the baery, remove the lock face by
pressing the tab and turning the lock face as
shown in the illustraon. Replace the old
baery and screw the lock face back in place.
40828-1806
4
14
SELECTING A LOCATION
The safe must be mounted to the floor. For
opmal safety and security, the safe should
be installed adjacent to a side wall with
minimal space on either side of the safe, in an
isolated, dry and secure area.
The safe should be flat against the wall and
floor. Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY WITH OR
AROUND THE SAFE AT ANY TIME.
TAB