7 Wearing parts
22 10.20133
BA_SLE22_EN.DOCX
7 Wearing parts
NOTICE
The SLE22 has no wearing parts. If a device is
faulty it must be replaced by an equiv
lent device. Note that the device must have the following characteristics:
• Identical or higher hardware status
• Identical or higher software status
• Identical or higher temperature range
These characteristics can be seen from the rating plate of each device (see Chapter 10).
The device can be purchased directly from the manufacturer or his sales partner. When
installing, Chapter 4.4 (Replacement of device and sensor) must be observed.
To Next Page
Loading...
