Stahl SLE22 - Target Group; Claims for Liability for Defects; Misuse and Malpractice

1 General information
10.2013 5
BA_SLE22_EN.DOCX
1.6 Target group
NOTICE
All
installation work and elimination of faults must be carried out by a
skilled electr
i-
cian, commissioning and maintenance by a qualified person.
The following must be observed
• EN 60204-1 and 32
• DIN VDE 0100
• DIN VDE 0110 and national accident prevention regulations
Skilled electrician
A skilled electrician possesses knowledge and experience on electrical equipment
arising from specialist training and, with knowledge of the applicable standards and
regulations, is able to assess the work with which he is entrusted and detect and avoid
possible risks. The skilled electrician must be familiar with the commissioning and
operation of the product and have been trained on it.
Definition of a qualified person:
A qualified person is one who has gained the specialised knowledge required for
testing the equipment from his/her vocational training, professional experience and
contemporary professional activity.
This person must be in a position to assess the safety of the system in conjunction with
the application. Qualified persons with the competence to undertake certain mainte-
nance work on our products include the manufacturer’s service engineers and trained
fitters with the corresponding certification.
1.7 Claims for liability for defects
DANGER
The prior condition for trouble
-
free operation of the device and settlement of any l
iability
claims for defects is compliance with the operating instructions.
• Read the operating instructions before working with the device.
• Use the device only for its intended purpose. Observe the content of sections "Tech-
nical data," "Use for intended purpose" and "Misuse".
• Observe the requirements of EN 60068-2-6 for transport, storage and operation (see
"Technical data").
• These operating instructions describe only the basic functions of the device.
• Do not open the casing and do not carry out any unauthorised modifications.
• It is essential to disconnect the supply voltage during maintenance work (e.g. when
replacing contactors).
• In addition to the information given in the operating instructions, official and legal
regulations on operation must be strictly observed.
1.8 Misuse and malpractice
DANGER
The device
may be used
solely
in accordance with the instructions and information given
in these operating instructions.