Page 29
[SELECT]“CONTRAST ADJ” 5
[SELECT]“MAX SPEED” - N/A- 6
[SELECT]“CLINICAL MODE”-N/A-7
[SELECT]“SET DEFAULTS “ 9
Machine Status Codes
[ ^ ] [ 4 ] [ 0 ] display machine run time in hours
[ ^ ] [ 4 ] [ 1 ] display number of workouts
[ ^ ] [ 4 ] [ 2 ] display distance traveled
[ ^ ] [ 4 ] [ 3 ] display software rev
[ ^ ] [ 4 ] [ 4 ] display machine type
[ ^ ] [ 4 ] [ 5 ] -N/A-
[ ^ ] [ 4 ] [ 6 ] display machine run time in hours since last cleared
(used for maintenance)
1. Display the machine run time by pressing [LEVEL: ^], [4], [0]. The console
will display “RUN HOURS XXXXX”.
2. Display the number of workouts by pressing [LEVEL: ^], [4], [1]. The console
will display “WORKOUTS XXXX.”
3. Display the total distance covered up to date by pressing [LEVEL: ^], [4], [2].
The console will then display “DISTANCE XXXX.”
4. Display the console software revision number by pressing [LEVEL: ^], [4],
[3]. The console will display “CONS 92111-XXX.”
5. Display the machine type by pressing [LEVEL: ^], [4], [4]. The console will
display “STEPPER (or other machine type).”
6. Display the machine run time since last cleared by pressing [LEVEL: ^], [4],
[6]. The console will display “MAINT HOURS XXXX.”
7000 PT CONSOLE
To Next Page
Loading...
