Page 27
CUSTOM SCROLLING MESSAGE
The message that scrolls across the text bar during the ATTRACT mode can be
replaced with a message of your choice. The console accepts messages up to
128 characters in length, including spaces. To program your message:
1. Encode your message using the character codes listed in Table 3.
2. While the console is in the ATTRACT mode, press [+ ARROW], [7],
[6], [0], [7], [ENTER].
3. Enter the two-digit code for each letter of your message. The
letter will appear in the text bar as you press the second digit of
each code. Do not press [ENTER] between the code numbers.
4. For example, to program the message “EXERCISE IS FUN”,
press [+ ARROW], [7], [6], [0], [7], [ENTER]. Then press [1], [5],
[3], [4], [1], [5], [2], [8], [1], [3], [1], [9], [2], [9], [1], [5], [1], [0], [1],
[9], [2], [9], [1], [0], [1], [6], [3], [1], [2], [4], [ENTER]. At that point,
your message will begin scrolling. The console is again in
the ATTRACT mode.
5. If you make a mistake while entering the codes, press [CLEAR] to
erase the last character entered.
STRATUS SYSTEMS CONSOLE
To Next Page
Loading...
