Page 34
MAINTENANCE INSTRUCTIONS
Quarterly Maintenance
1. Clean and thoroughly lubricate the drive chain and adjust the chain
tension every three months. Follow the chain removal and tensioning
procedures in the “Parts Removal and Replacement” section. Use a
degreaser to clean the accumulated grime from the chain. Lubricate
the chain with a spray-on chain lubricant such as Tri-Flow
™
before
installing the cover.
!
WARNING
TO AVOID POSSIBLE BEARING FAILURE, DO NOT LUBRICATE THE SEALED
BEARINGS ON THE INTERMEDIATE SHAFT, OR THE CRANK. THEY ARE
LUBRICATED AT THE MANUFACTURING PLANT.
To Next Page
Loading...
