8
Numeric and Cursor Keys
All parameters may be adjusted using the cursor or
numeric keys. When using the cursors, the digit
being adjusted in the center display will flash. The
UP and DOWN keys increment and decrement the
digit. The LEFT and RIGHT keys select the
flashing digit. When using direct numerical entry,
simply press the number and decimal point keys
until the desired value appears on the center
display. Note that the current is specified in mA.
Instrument Status
Three LED's indicate the instrument's status. The
LIMIT LED is on when the unit is in current limit.
REM is on when the front panel is locked out.
SRQ is on when a GPIB service request is pending.
Other Keys
RESET sets the reset mode to either AUTO or
MAN (manual).
GPIB displays the GPIB address in the center
display so it can be adjusted. It is also the LOCAL
key when the unit is in the remote mode.
Store and Recall
STO (store) and RCL (recall) allow up to 9
complete instrument settings to be saved in
nonvolatile memory. RCL 0 recalls the default
settings.
To Next Page
Loading...
