24
WI-FI OPERATION
The Cara Stove can be operated remotely using the
myfire app by connecting the optional myfire Wi-Fi
Box (Part Code: B6R-W) and connecting same to a
Home Network (Wi-Fi Router). The myfire Wi-Fi Box
will operate for a short period of time using batteries
but if mains power is lost for a period of time, it is
recommended to disconnect the Wi-Fi Box from the
Gas Valve Control Box. To set-up the myfire Wi-Fi
Box, use the following procedure:
1. Connect the data cable to the Gas Valve
Control Box & myfire Wi-Fi Box (refer to
Wiring Diagram).
2. Connect the Mains Adaptor to the Gas
Control Valve. After 30 seconds the myfire
Wi-Fi Box goes into Access Point Mode & the
green LED flashes - see Fig 47.
3. Download the myfire App from Apple App
Store or Google Play Store.
4. Start App setup.
5. Choose language, temperature (Celsius or
Fahrenheit) and time format (12 or 24 hour).
6. Complete the registration process and Login
to the App.
7. Touch the + icon and a message will tell you
to go to your smart device Wi-Fi settings.
8. Touch myfire_WiFi-Box_<number>.
9. Enter the password “MYFIREPLACE”.
10. Select a name for your stove.
11. Type in the name (SSID) of your Wi-Fi router.
12. Type in the password of your Wi-Fi router.
13. Touch “Connect” button.
14. After successful connection a pop-up will tell
you to go to your smart device Wi-Fi settings.
Touch “OK” if the settings are correct.
15. After confirming fireplace settings touch
“Finish”.
16. Touch “Start App” to finish the installation &
setup process.
NOTE: If any of the Automatic Operation
Modes are activated using the App,
“APP” will be displayed on the
Remote Control.
For further instructions & video on how to set-up the
myfire App, see http://myfireapp.com/en/setup/.
MAINTENANCE
This stove must be inspected and serviced once
a year by a qualified/competent Gas Engineer.
CLEANING THE OUTER CASING
Cleaning should be done when the stove is cold by
removing any dust or dirt using a dry cloth. Do not
use any water on the matt black/senotherm finish as
this will cause it to rust.
Fig.47
CO ALARM
The fitting of CO Alarms in the same room as the
appliance is a compulsory requirement under cur-
rent Building Regulations. For ROI an additional CO
Alarm must be fitted either inside each bedroom or
within 5 metres of the bedroom door, refer to
Building Regulations Part J. Further guidance on the
installation of a carbon monoxide alarm is available
in BS EN 50292:2002 and from the alarm manufac-
turers instructions.
Provision of an alarm must not be considered a
substitute for either installing the appliance
correctly or ensuring regular servicing and
maintenance of the appliance and chimney
system.
WARNING:-
If the CO Alarm sounds unexpectedly:-
1. Turn off the stove immediately.
2. Open Doors and windows to ventilate the
room and then leave the premises.
To Next Page
Loading...
