Stanley Compulevel User Manual

Compulevel
TM
Measurement system • 14
3) Move the measurement module below to the desired elevation, half the
band.
4) Press the MARK key momentarily, while holding the unit steady, to set
the audible tone.
To use the MARK function: to create audible tones outside the
measurement band:
1) Place the measurement module at the desired elevation.
2) Press and hold the MARK key for two seconds. Hold the unit steady
until double band lines flash in the display window.
3) Move the measurement module above to the desired elevation, half the
band.
4) Press the MARK key momentarily, while holding the unit steady, to set
the audible tone.
Note: this procedure will create a solid audible tone above the
measurement band and a warbling tone below the measurement band.
There will be no tone within the band.
Notes: The fraction bar flashes in the display window to indicate that you
are in the MARK function.
To exit the MARK function and retain setting, momentarily press the
MARK and ON/OFF keys together.
Press the MARK key for two seconds to re-enter.
Tones can supplement display to level or alarm at height limits.
Enter at elevation Set band
Double beep Single beep
USE FOR PRECISE LEVELLING
USE FOR PRECISE LEVELLING
BEST FOR ROUGH LEVELLING OR
ELEVATION LIMIT INDICA
TION
T
one
No tone
T
one
No tone
Band
Steady
No tone
Beeping Tone
STEP 1 STEP 2
DISPLAY
TONES
TONE
AT
MARK
TONE
INSIDE
OF
BAND
TONE
OUTSDE
OF
BAND
Mark
47855 CompuLevel 6/11/07 11:14 Page 14

Stanley Compulevel Specifications

General

Brand	Stanley
Model	Compulevel
Category	Measuring Instruments
Language	English