19 • Compulevel
TM
Measurement system
Inspect/Dump and Initialise
INSPECT or DUMP
This function allows inspection of previously gathered measurement data
and/or data transfer to a PC.
To use this function:
• Momentarily press the CAL and REC keys together to dump data to PC.
• Press and hold CAL and REC keys together for two seconds to inspect
data.
• Momentarily press the MARK key to sequence up through positions.
• Momentarily press the REC key to sequence down through positions.
• To sequence up or down in multiples of ten positions, momentarily
press the CAL key for up and the HOLD key for down.
INITIALISE
This function resets all user settings to default values (COMPULEVEL
TM
must be re-calibrated in this case, see calibration on page 11). This
function also returns the user from any function to the normal display
function.
Note: This is a sure way to recover from an unwanted function.
To INITIALISE:
Press and hold the CAL, REC, MARK and hold keys together for two
seconds using two fingers of each hand with the measurement module on
its back on a flat surface.
INSPECT/
DUMP
Click CAL and REC momentarily and
release to DUMP DATA to PC
Pr
ess
CAL and REC two seconds to
enter or exit INSPECT
INSPECT POSITION CONTROL KEYS
Serial – link
Pocket PC or…
Palmtop mounted to unipod or held in left hand with
display visible operator
RECORDING DATA ‘ON THE FLY’
When COMPULEVEL
TM
registers fill, ‘FULL’ will display
but record date to PC can continue indefinitely.
TENS TENS
ONES
ONES
Sequence
down
Sequence
up
HOLD
CAL
MARKREC
To Next Page
Loading...
Need help?
General
