Compulevel
TM
Measurement system • 8
Mechanics of Use
Labelled Functions
The following section describes how to operate COMPULEVEL’s labelled
functions. Glance through all the functions and the example illustrations
then try each function on your COMPULEVEL
TM
.
ON/OFF
Momentarily press the ON/OFF key to turn COMPULEVEL
TM
on or off. If no
key is pressed, or the measurement module is not moved in four minutes,
the unit powers down automatically. The unit emits two long warning
beeps after three minutes of no movement or keypad activity to warn of
shut-off activity.
HOLD
The HOLD function is used to make and retain a measurement from any
location where the display is hard to see, such as overhead, in a deep
trench, or anytime you want to hold a measurement on the display while
moving the measurement module. The HOLD function is toggled on/off by
momentarily pressing the HOLD key.
Typical Handling Suggested Reeling Technique
M
anage cord with left hand, gently
‘
whip’ over small objects.
T
humb can
r
each the 3
m
ost used
keys
For consistent readings,
balance with unipod
b
etween middle fingers like
a plumb-bob before
c
ontacting surface.
Easiest cord
removal
d
irection
Cord Removal
Quick jerks may cause reel
over-spin and cord jams
Avoid pulling or winding
cord in docking area
Docking ar
ea
R
est ‘round’
against thigh
Dock
m
easur
ement
module face-up
Slowly move from side
t
o side to make cord
uniform on reel
To Next Page
Loading...
Need help?
General
