Screw the SA Spin Pull Head into Front
Unit Assembly. Tighten it using a wrench.
Set torque to 30Nm.
Insert desired size Mandrel into SA Spin
Pull Head. Screw tightly with hand.
When feel tighten, return a little bit
until the lock pin locked the mandrel.
Set a battery on to the tool to check the
operation. Check the tool operates
correctly by pulling and releasing the
trigger.
Check for:
⚫ Pulling operation
⚫ Return operation
⚫ Reset operation
⚫ Full stroke → Stroke end clutch
operation → Return to home
position → Front end clutch
operation
Remove the battery after checking.
To Next Page
Loading...
