Stanley PB2500 - Tool Operation and Setup; Power On; Selecting a Counter

- 10 -
Tool use and Set up
1. Power ON
Pull trigger and release.
Power On and shows ”Stanley Engineered
Fastening” logo on the screen.
After showing logo for a few seconds, the
screen is switched to Counter window
automatically.
*Power OFF for 3 minutes automatically after
trigger was pulled or the screen was touched
last.
2. Selecting a counter
Various counters can be used. By referring to the following descriptions, Switch
ON/OFF these counters accordingly.
・Poka-Yoke : Use this as Poka-Yoke counter
・Service1 : Use this as Free counter
・Service2 : Use this as Free counter
・Service3 : Use this as Free counter
・Mandrel : Use this as Alarm to empty collector (Default 100)
・JAW : Use this as Alarm to do Jaw maintenance (Default 3,000)
・OVERHAUL : Use this as Alarm to overhaul (Default 50,000)
・Daily : You can see the numbers set per day
・Monthly : You can see the numbers set per month
・Total : You can see the total numbers set